• Air and Fluid heating solutions
• Renewable energy
• Industry
• Ventilation
• Agriculture and Farming

Main applications :
Use in areas where IP65 waterproofing is required. Medium positive, negative or differential pressure detection. Water level measurement, detection of clogging of water filters.Minimum water pressure detection on water heaters and boilers. This pressure switch is much more sensitive than snap-action systems and can be calibrated at lower pressures, but its use is limited to low power applications, typically on electronic circuits. Very low differential, less than 1 kPa (10 millibars, 0.15 PSI)

Membranes: Silicone, dia. 22mm.

Fluid: Water or air. (Connection of liquid on the negative pressure portis not allowed) Fitting:
- Negative port by flexible PVC tube 3 × 6mm length 200mm (Other length on request)- Positive port by ⅛” BSPT or NPT or ¼” BSPP thread in PA66.

Housing: PA66, UL94 VO, IP65 Ingress protection
Contact: Single pole normally open, slow make and break.

Electrical rating:
- Silver contact: max 1A 250VAC
- Gold plated contact: max 100mA, 24VDC
Action: Momentary, close on pressure rise on the positive port.

Set point calibration: Factory calibrated and sealed, not field adjustable
Set point calibration limits: From 10 to 400 kPa (100 to 4000 mbar, 1.5 to 60 PSI)
Electrical connection: PVC insulated cable, 2 × 0.2mm² (AWG24)
Maximum pressure: 4 bar (0.4 Mpa, 60 PSI)
Bursting pressure: > 16 bar (1.6 Mpa, 232 PSI)
Electrical connection: AWG24 cable, UL 2464 style, length 500mm (other lengths on request) Ambient temperature limits: water: 0 to 85°C (32 to 185°F), Air: -10 ~ 85°C (14 to 185°F)